 |
- Home
- Roofing Products
- Wall Coatings Products
- How it works
- Roofing Approvals
- Architectural Specs
- Application Specs
- Warranty
- MSDS
- FAQ's
- Contact Us
- News & Updates
3100 EPDM/Single Ply Primer
Note: You may also view these documents in Adobe Acrobat Reader(.pdf format).
Click Here to view this document in .pdf Format
- 3100 is a high quality, EPDM/Single Ply primer that is formulated to promote maximum adhesion.
- 3100 is a high pH, rinseable primer that can be used to clean most surfaces.
- Although 3100 is not harmful to the
environment, proper care should be taken during application. Protective eyewear
and gloves must be used. Surfaces treated with the
3100 can be extremely slippery when wet. Always use fall protection when working on roofs.
Application: can be brushed, rolled or sprayed. Application rate (approximately 500 Sq. Ft. Per gallon) will vary with the porosity of the surface. Allow ten to fifteen minutes to activate before power washing, with a minimum of 2000psi. The surface should be clean and dry before the installation of an AcryLabs System. Dry time will vary depending on temperature, humidity and ventilation.
3100 is available in 1 and 5 gallon plastic containers.
3100 TECHNICAL DATA
TYPICAL PROPERTIES
APPEARANCE
Clear pink liquid
WEIGHT PER GALLON
Approx. 8.3 Lbs.
PH
13.0 – 13.5
VISCOSITY
Same as Water
Wet adhesion of 2100B and 2100 to EPDM Membrane
Preparation
Wet adhesion (pli)
None
.7
Power wash/water
.7
Prepared with 3100 Primer
1.8
"We cover the future . . . and the past."
Renewable - Sustainable - Seamless - Environmentally Responsible
Exceptional Durability - Flexible - UV Resistant - ASTM Tested
Reduces Energy Costs - Outstanding Performance - Unmatched Service
About Us - Products - News - Trade Shows - Contact Us - Sitemap - Home